Identificador: 2590
Abierta
Descripción
PART: 12588 – RECIPROCANTING - SPRAY LINE UV - GIARDINA
USED - GOOD CONDITION
CAPACITY: 12 SPRAY GUNS, 2 CIRCUITS
HOT AIR TUNNEL, CAN USE HOT WATER FOR HEATING
INFRARED TUNNEL
UV ED TUNNEL FOR EDGE DRYING
IR AND UV OVENS ARE NEW, JUST 1 HR USE SINCE INSTALLATION
CURRENTLY INSTALLED AND WORKING
VIDEO: https://vimeo.com/1048779881
Pago y Devoluciones
- Forma de pago
- Visa/Mastercard/American Express, Bank Transfer/Direct Debit
Publicar mensaje
Ingresar para hacerle una pregunta al vendedor.
AMXmachine
PART: 2SP-S-2415 - WOOD SHREDDER - MOTOR 15 HP - INLET HOPPER 24” WIDE X 36” DEPTH
PART: 2SP-S-2415 - WOOD SHREDDER - MOTOR 15 HP - INLET HOPPER 24” WIDE X 36” DEPTH NEW WITH WARRANTY24" wide cutterhead block, 24" wide x 36" deep inlet hopper.15 HP motor/gearbox drive, prepared to operate on 208-230 volts 3 phase power with master control panel & emergency stop included.Generates solid material into approximately 3/8" x 1" sizes.A robust fabrication design built for many years of daily, commercial use suitable for all types of soft or hard wood, plywood, MDF, plastic ma...
AMXmachine
PARTE: 2MA- FP-2560 – LIJADORA 1 LIJA - CALIBRADORA DE METAL – 25” ANCHO - 1 LIJA
PARTE: 2MA- FP-2560 – LIJADORA 1 LIJA -
CALIBRADORA DE METAL – 25” ANCHO - 1 LIJANUEVA CON GARANTIASpecifications:
Model
FP-2560 FP-4075 FP-5285Sanding
Capacity 24”
x 6-1/8” 40” x 6-1/8” 51” x 3-1/2”Abrasive
Belt ...
AMXmachine
PART: 12529 - VENEER GUILLOTINE - 2 KNIFE - 3200 MM - MONGUZZI
PART:
12529 - VENEER GUILLOTINE - 2 KNIFE - 3200 MM - MONGUZZI
USED - VERY GOOD CONDITIONS
Model TRM-2L 3200
Capacity 3200 MM
Hydraulic
Mfg. 1995
Sharpened knives
New mats
AMXmachine
TRISCADORA 10-60 MM AUTOMATICA
PART # 4VF-SV80ATV - TRISCADORA PARA SIERRA CINTAS 10 -60 MM - AUTOMATICANueva con garantiaAutomatic work cycle. Choice of type of setting: left/right or left/right/straight. Adjustment of the feed pitch, of the setting height and of the tooth bending degree. High-yield in very little workspace. Complete with base and with rod and roller to support saw blades.Bandsaw Thickness [min-max]: 0,5 – 1,2 mmBandsaw Width [min-max]: 10 – 60 mmSetting Pitch [min-max]: 5 – 35 mmSetting Speed [d...