Identificador: 2272
Abierta
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
PART: 12473 - KITCHEN CABINET - COUNTERTOP MANUFACTURING LINE - EVANS
AMXmachine
Descripción
PART: 12473 - KITCHEN CABINET - COUNTERTOP MANUFACTURING LINE - EVANS
USED - GOOD CONDITION
INDEX TABLE
PINCH ROLLER
POSTFORMER
COVING BACKSPLASH
POSTFORMER 0110
Pago y Devoluciones
- Forma de pago
- Bank Wire Transfer
Publicar mensaje
Ingresar para hacerle una pregunta al vendedor.
-500x500.jpg)
AMXmachine
PART: 12575-E – BAND MAGNETIC SEPARATOR
PART:
12575-E – BAND MAGNETIC SEPARATOR
Unused,
“New” Conditions
Motor:
3 HP, 230/460V/3/60
Marca:
Wolverine
29-1/2”
wide x 70” long Belt
Motor:
WEG 3HP
Approximate
Weight/unit (kgs): 776
Aproximate
Pack Size/unit - L*W*H (mm) : 2276 * 1216 * 572
Speed
- It is fixed speed and can be changed with a controller.
Magnet
power is strong - the original design was to pull small scrap metal from sand
on conveyor belt.
AMXmachine
PART: AMX-10028 - DOBLE MITER SAW 45 DEGREE – 14” DIAMETER - PISTORIUS EMN-14
PART: AMX-10028 - DOBLE MITER SAW 45 DEGREE – 14” DIAMETER - PISTORIUS EMN-14
Used - Very good condition
2 Motors 2 HP,
208/230/460 Volts, 60 Hz, 3450 RPM
2 New On/Off
Switches with magnetic starters WEG
Saw harbor
5/8"
Dust exits 2 of
4" diameter, requres aprox. 850 CFM
Air use 72 CFM at
65 PSI based in 15 cycles/min
Table height
36-1/8" (917 mm)
Guide Left: 37” largo
Gude Right: 22”
largo
Pneumatic pedal
Each cut takes 4 to
6 seconds
Shippi...
AMXmachine
PART: 3AU-DEBU1000 – METAL - BRUSH SANDER – CAPACITY 1000 MM WIDTH
PART: 3AU-DEBU1000 – METAL - BRUSH SANDER – CAPACITY 1000 MM WIDTHNew with warrantyRound Chamfering Machine produces a surface so smooth that a nylon stocking is not snagged. AuDeBu1000 is a deburring machine specializing in round chamfering and capable of simultaneous treatment of large quantities of small-size work and medium-size work up to 1,000mm wide. Round chamfering of product edges has become the standard in sheet-metal processing. As the demand for round chamfering increases, we ca...
AMXmachine
PART: 2CA-CM-8CAR-E - MANUAL COPY CARVING MACHINE
PART: 2CA-CM-8CAR-E - MANUAL COPY CARVING MACHINEFeatures:Special design 3D carving machine by menu copy with template for wood, artistic, and plastic, etc.Fix the template at middle axis, the other 8 axis spindle will follow it and carving the material when it is automatic rotated 360 degrees.The spindle motor controlled by high frequency inverter from 9,000 to 12,000 RPM for best carving effects.Cutter head can be adjusted at x or y direction.Carving angle can be adjusted at 30 to 120 degrees...